Bugaboo...Let's make a Bobble Head...

Bugaboo Tutorial

Hey all...Welcome to my short tutorial on how to make a Bobble Head with a regular BUGABOO Image. You can find super cute Bobble head images at Bugaboo that takes all the guess work out of measuring...But i wanted to show you how to create one with just any image they carry.

I have had such fun with this type of card..So easy to do and so much fun.

 

Let me show you how i create a Bobble Head

 

Now i ended up putting this on a standard size A2 Card so i printed the full image 7.4cm x 6.0 cm.

Then i cropped another image as you only need the head at 7.5cm x 6.0cm. It's hard to tell by the measurements but as long as the top head is bigger than the bottom and you can fit your Bobble behind it you are good to go.

 

 Then i coloured this cute POLKAB side sit Bugaboo image in my favorite bunny colours. You can find her HERE.

Cut them out, and as you can see i ended up cutting the ears off the smaller one as when i placed the larger head on top they were poking out too much for my liking.

 

 

Get all your card papers, embellishments and sentiment together.

 

Glue down everything but the larger head at this point..

 

 

Peel the paper off the top pad of your wobble and place at the back of the head...You can trim this down a bit if needed.

 

 

 You are now ready to peel the base pad paper off.

 

 

Place just above the neck on top of smaller head of bunny...there you have it super simple, easy and such fun..you can watch the movement below...HAPPY EASTER everyone!!

 

 

Thanks for dropping by...